1) Unplug all cameras from the NVR. 2) Do the factory reset so the NVR is configured with DHCP onto the new network. 3) As you plug each camera in, hold the reset button for approx 10 seconds. This resets camera (obviously) which then puts the camera on the correct network and inherits the new admin password. As you can see in the diagram, the DVR has the IP 192.168.0.1, and the laptop has g the 192.168.1.2, which is on a different subnet range. (supposing both are using the same subnet mask 255.255.255.0). HIKVISION -- How Setup IP CAMERAIn this video, I will guide to setup a IP camera with activate, change IP address, time settings, enable Hik-connect, schedul Answer: Follow the process below once logged into the IVMS-4200: In the "Main View"click on the "Enable Alarm Pop-Up Image". To disable it, click that same button again. Alternatively, this can also be done through the the IVMS-4200 "Event Center". Click on the "Home" button in the upper left corner of the IVMS-4200. Jan 1, 2016. #3. Hi Harold, I have set a Scene as External Webcams, from this the Source is Hikvision Webcam, right clicking on this, the device selection is IP Camera, using the configure tab, in IPCam properties I have ticked 'use basic authentication', entered the cams username and password. The interface is v5.8.6.0 from www.webcamXP.com. • Check the Computer IP address, must be in the range of the DVR IP, like if DVR IP is 192.168.0.2 than computer IP must be ranging from 192.168.0.3 – 192.168.0.254. • Remove the tick [√] from enable DHCP option in menu > configuration > network > TCP/IP > disable DHCP > assign the local IP manually > Apply. .

hikvision ip camera activation password